Reverse osmosis pilot station

Reverse osmosis test station Mod. OI/EV and OIa/EV is a modern training and research facility that allows for the analysis and optimization of the reverse osmosis process. This technology, when applied to a pressure exceeding the osmotic pressure, allows a solution to pass through a semi-permeable membrane to remove dissolved substances and provide water purification or desalination of salt water.

Curriculum:
The device allows you to study the following processes:

• Effect of operating pressure;
• Effect of inlet flow rate;
• The effect of UV light sterilization on leakage;
• The ratio of concentrated to leaked solution;
• Optimization of the reverse osmosis process;
• Automatic PID control (only Mod. OIa/EV);
• Device maintenance and control via computer (Mod. OIa/EV only).

Technical characteristics:

• AISI 304 stainless steel construction with casters;
• AISI 316 stainless steel supply tank, capacity – 90 l;
• AISI 316 stainless steel overflow tank, capacity – 60 l;
• AISI 316 stainless steel piston feed pump with microfilter (5 µ), flow rate from 0 to 700 l/h, Pmax = 60 bar;
• Magnetic drive gear pump to transfer flow to the UV lamp;
• Safety pressure switch;
• Osmosis membrane with AISI 316 stainless steel body;
• AISI 304 stainless steel Bourdon pressure gauge, range from 0 to 60 bar;
• Variable area flowmeters:
  • 20-200 l/h (only Mod. OI/EV);
  • 80-800 l/h (only Mod. OI/EV);
  • 100-1000 l/h (only Mod. OI/EV);
• UV lamp for flow-through sterilization;
• Microprocessor conductivity meter with stainless steel sensor, range from 0 to 2000 µS/cm;
• AISI 304 and 316 stainless steel fittings and valves;
• IP55 protection class control panel with CE mark and emergency button;
• Windows maintenance software (Mod. OIa/EV only) allowing monitoring of real-time and historical data, control of ON-OFF signals and analog parameters.

Dimensions and power supply:

• Dimensions: 1700 x 700 x 2080 mm;
• Weight: 250 kg;